All versions newer than 1.3.0
(The version of the application this issue occurs with.)
Windows 10
(Information about the operating system the issue occurs on. Include at least the operating system and maybe GPU.)
Epsilon W50
(Which printer was selected in BCN3D Stratos?)
Reproduction steps
- I do a fresh installation of BNC3D Stratos.
- Without changing any settings i import a stl and slice it with IDEX Single 2.
Actual results
The right hotend begin to print but after a while it pauses and then the left hotend warm up and moves to the model and back again. If i search after T0 in the sliced gcode it apppears in more places than the final shutoff.
Expected results
The left hotend should not warm up or move at all since it´s deactivated. If i do the same steps as above for IDEX Single 1 it works as expected and when i search after T1 in that sliced gcode it only appears one time at the end when it shutoff.
All versions newer than 1.3.0
(The version of the application this issue occurs with.)
Windows 10
(Information about the operating system the issue occurs on. Include at least the operating system and maybe GPU.)
Epsilon W50
(Which printer was selected in BCN3D Stratos?)
Reproduction steps
Actual results
The right hotend begin to print but after a while it pauses and then the left hotend warm up and moves to the model and back again. If i search after T0 in the sliced gcode it apppears in more places than the final shutoff.
Expected results
The left hotend should not warm up or move at all since it´s deactivated. If i do the same steps as above for IDEX Single 1 it works as expected and when i search after T1 in that sliced gcode it only appears one time at the end when it shutoff.