What do I do now?

[pwaugh]

So, I screwed up the setup on my 4.3B Touch and cannot connect now with the web page.

It said to try a hard reset, but I have no clue how to do so. I am using an iMAC.

Thanks, Patrick

[pwaugh]

I figured it out. It is programmed successfully.

[Builty]

Hi Patrick.
Two options exist for doing a reset back to the default config:

1. press and hold footswitch button 1 for approx 15 seconds. Board will reboot and reset to default. If you aren't using directly connected footswitches, you could temporarily connect footswitch 1 input to ground, and wait the time

2. Use the programming app to perform a full erase, and then flash again. This works for sure on the Windows app, but being a Mac, you would be using the web tool. I haven't used erase from it but it has an erase button that should do it.

[Builty]

Ha you fixed it while I was typing.

[pwaugh]

Thanks for trying to help. It programs, but then when I disconnect it from the USB and turn it on, nothing. LOL