Hello, I have a Polar Plus running firmware version 2.0.3.2, which I use to control an IK Multimedia TONEX ONE. I have experienced a strange issue twice during rehearsals in the same studio. In the middle of a song, the Polar Plus suddenly returned to Preset 1. I did not notice any reboot or power interruption, and I did not see the usual resynchronization message on the display. The Polar Plus simply appeared to be back on Preset 1. The Polar Plus is powered from the 9V output of an MXR Mini Iso-Brick power supply on my pedalboard. At home, if I switch the power off and then back on, the Polar Plus correctly restores the last preset I was using. Therefore, I don't think this is a normal startup behavior. Could this be caused by an unexpected MIDI message or a MIDI synchronization issue coming from the TONEX ONE? Is there any known issue with firmware 2.0.3.2 that could cause the Polar Plus to return to Preset 1 without rebooting
Hello, I have a Polar Plus running firmware version 2.0.3.2, which I use to control an IK Multimedia TONEX ONE. I have experienced a strange issue twice during rehearsals in the same studio. In the middle of a song, the Polar Plus suddenly returned to Preset 1. I did not notice any reboot or power interruption, and I did not see the usual resynchronization message on the display. The Polar Plus simply appeared to be back on Preset 1. The Polar Plus is powered from the 9V output of an MXR Mini Iso-Brick power supply on my pedalboard. At home, if I switch the power off and then back on, the Polar Plus correctly restores the last preset I was using. Therefore, I don't think this is a normal startup behavior. Could this be caused by an unexpected MIDI message or a MIDI synchronization issue coming from the TONEX ONE? Is there any known issue with firmware 2.0.3.2 that could cause the Polar Plus to return to Preset 1 without rebooting