Hardware Compatibility

[Elwinmage]

If you have devices with a compatibility marked as " ☑️ Must Work" in compatibility table can you please confirm that it works.

✅ Fully Tested ☑️ Must Work ❌ Not Supported Yet

	Model		Status
ReefLed	G1	RSLED50	✅
		RSLED90	✅
		RSLED160	✅
	G2	RSLED60	☑️
		RSLED115	✅
		RSLED170	✅
ReefMat	RSMAT250		✅
	RSMAT500		✅
	RSMAT1200		✅
ReefDose	RSDOSE2		✅
	RSDOSE4		✅
ReefATO+	RSATO+		✅
ReefControl	RSCONTROL		❌
ReefRun & DC Skimmer	RSRUN		✅
ReefWave	RSWAVE25		☑️
	RSWAVE45		✅

[GJL44]

Confirming ReefMat RSMAT500 works as intended.

[Elwinmage]

Thx @GJL44

[Grimlogh]

RDOSE2 seems to be working fine for me at a first glance. Reads out paramters well

RSLED90 G1 - unfortunately seems to be stuck in initialization

[Elwinmage]

It seems that the light response is very slow and homeassitant kill the task .
To be sure can you activate debug mode like describe in my previous message

[Grimlogh]

Yes it seems to react very slow. Which also is the case in the ReefBeat App unfortunately. Maybe it is something with my WiFi but not having issues with other devices. Will send you the DebugLog

[Elwinmage]

Hi @Grimlogh, i just patch the issue #22 relative to some RSLDE90 in pre-release v0.9.2. Without debug log i don't know if it could be linked to your bug. Could you just try this two requests:

• http://<your_LED_IP>/dashboard
• http://<your_LED_IP>/preset_name

[Grimlogh]

Hi @Grimlogh, i just patch the issue #22 relative to some RSLDE90 in pre-release v0.9.2. Without debug log i don't know if it could be linked to your bug. Could you just try this two requests:

• http://<your_LED_IP>/dashboard
• http://<your_LED_IP>/preset_name

@Elwinmage - sorry did not notice your reply - was going through a reef-rebuild in a new tank and took the ReefLed out of service and switched to an ATI Straton Pro G2. Sorry can't perform the two requests

[Elwinmage]

ok thkx

[rkarolek]

RSMAT250 works very well, good job :)

[stereotone]

Confirming ReefLED RSLED50 G1 is working very well. Thanks 👍

[Elwinmage]

thx for the info @stereotone