ZG-103Z Device specific settings missing - No Calibration

[konqueror81]

Hi, I bought some of these sensors and they work fine, they are supported and immediately recognized, but I can't do the calibration that should be in the "device specific settings" as specified here https://www.zigbee2mqtt.io/devices/ZG-103Z.html. When I go to the menu I get this message: "Empty exposes definition". I have already enabled "Home Assistant experimental event entities" and "Home Assistant legacy action sensors", but nothing. Thanks in advance for the future fix

[RGadermann]

Same with me for all 18 sensors. Re-pair and battery replacement without success.

[jayceegee87]

Same here. The sensor seems to perform reliably, however there is no way to calibrate the axes to ensure the tilt function performs accurately.

[konqueror81]

I’m using sensors on the windows, and to check if they’re tilted open (vasistas), I had to record the Z-axis values of each individual sensor when the window is open and when it’s closed. No sensors have the same values. With this workaround, I’m able to use them effectively, but it works without any real calibration. The vibration function works well, but only when set to low; otherwise, I get a lot of false positives.

[wunni1]

I've this sensor also and there is the problem that interview always fails (Message: "Interview fails because cannot get active endpoints" and "z2m: Request 'zigbee2mqtt_2/bridge/request/device/interview' failed with error: 'interview of '0xa4c1380e8ffa292f' (0xa4c1380e8ffa292f) failed: Error: Interview failed because of failed IAS enroll (zoneState didn't change ('0xa4c1380e8ffa292f')"). But: the sensor works. Vendor is HOBEIAN. . Tried to reset and repair a few times.

Any ideas?

[iDontWantAUsername]

Did anyone here manage to find a fix for this issue?