Cannot change the default IP address on 3A

[gtotev1]

I am using FTC REV hub which cannot route. Therefore, I cannot connect to the camera from my Mac when the camera is connected to the hub. That makes maintenance (uploading pipelines, configurations, upgrades) quite challenging when the camera is mounted on the robot.
In the Quicktstart Guide there is an option to change the IP address but I do not see it in 3A 2025.1 firmware. Can you please add it back? Thanks!

[liangbin-pub]

Limelight driver has port forwarding set up so use your robot IP with port 5800-5809 works just fine