Hello Nate711,
I flashed your customized firmware based on version 0.4.0, but it sometimes caused the uncontrolled spinning of some motors. These motors will spin up to full speed if I use odrv0.axis0.requested_state = AXIS_STATE_CLOSED_LOOP_CONTROL. I tested the firmware of version 0.4.0-master, it still happened. But after I flashed version 0.4.11-master, it works. So maybe some problems existed in version 0.4.0. For stablely running and widely spreading your research results, could you please migrate your changes to version 0.4.11?
Thank you.
Hello Nate711,
I flashed your customized firmware based on version 0.4.0, but it sometimes caused the uncontrolled spinning of some motors. These motors will spin up to full speed if I use odrv0.axis0.requested_state = AXIS_STATE_CLOSED_LOOP_CONTROL. I tested the firmware of version 0.4.0-master, it still happened. But after I flashed version 0.4.11-master, it works. So maybe some problems existed in version 0.4.0. For stablely running and widely spreading your research results, could you please migrate your changes to version 0.4.11?
Thank you.