When we convert resistance to temperature we cannot read below 35 deg

[shortyishere]

The resistance stops at 30,000 ohms?

[alexburcea2877]

You have right, we limited the resistance value to 30K because of the high errors in measurements above that value.

[shortyishere]

Agreed. Inaccurate numbers would give us something to see if it goes below freezing on a typical type 2 10k thermistor which is used by most manufactures. Is there a way we can adjust this if needed. And maybe a firmware that we could use with this enabled.

[alexburcea2877]

No problem to increase that limit in firmware if you need it. I will let you know when is ready

[alexburcea2877]

We released a new firmware version, the resistance limit has been increased until 60K ohms. Please update the card firmware, instructions here: https://github.com/SequentMicrosystems/megabas-rpi/blob/master/update/README.md

[shortyishere]

Awesome that should be good for our needs. Appreciate it!

[alexburcea2877]

I think we overreacted by setting the limit to 30K. Thank you for pointing this.