Joycon and Junglecat rails need support for printing. I have a manual support option inspired by Tokytome's Joycon knuckle dusters which leaves a slight gap between layers. It sorta works but I often can't see the line (I pull off some rail), and the technique depends on layer height (causes problems for adaptive). Removal is best done with an exacto, in which case you don't need a gap, but I'd rather it be tool-free. Make a tab that sticks out and can peel away.
Joycon and Junglecat rails need support for printing. I have a manual support option inspired by Tokytome's Joycon knuckle dusters which leaves a slight gap between layers. It sorta works but I often can't see the line (I pull off some rail), and the technique depends on layer height (causes problems for adaptive). Removal is best done with an exacto, in which case you don't need a gap, but I'd rather it be tool-free. Make a tab that sticks out and can peel away.