Small Bug regarding "command?SetHeatpump=0"

[Bender2k]

If i send "command?SetHeatpump=0" the response is: "set heatpump state to 1"
If i send "command?SetHeatpump=1" the response is: "set heatpump state to 2"

Sure, just a small bug, but i can't unsee it. ;)

[IgorYbema]

In fact it is the way the status works inside of the heatpump. State 1 = off and state 2 = on.
And the first few commands that where coded got this way of logging. But I do agree that it is now confusing so I'll change it

[Bender2k]

Ok, understand.
The confusing part is that the Heatpump Status in the Heishamon Web Interface also says "Value" 0 and 1.

(What i mean is, its "translated" there also ;) )

[IgorYbema]

Yes, correct.
You are just looking at ancient code which never got changed anymore because if it works, it works :-)