tool change

[zu4lu]

Hi, hope this is the correct place. Gmoccapy on linuxcnc 2.8, the latest probe-screen-ng. Remap m6: first using ts height, than workpiece height, works perfectly. Then requesting a tool change with m6 tx, spindle goes to change point and after pressing the tool is changed button, i get: "it is not possible to change to auto mode in the moment". No tool length measure, nothing. Any idea, thanks
Michael

[CamHaug]

As per the linuxcnc thread - I seem to be suffering from this - I don't get the same error but I am using axis not gmoccapy. It just hangs and I have to reload gcode and start from scratch. If it detects that the correct tool is loaded then it will continue.
In the hung state it still has psng_manual_change.ngc loaded if that helps.

[pnousiai]

I have same issue. Anyone figured out how to fix it?. When I click ok to dialog nothing happens.

[nostahl]

ya im getting this same issue its now 2023 if I MDI Tx M6 G43 it moves over and then asks for the tool I click ok after I put it in and then nothing.. if I MDI the command again THEN it will probe the tool on the tool length setter and continue happily along with the gcode... what is the issue?

[looping40]

I'm also facing the same issue