Support for the ZG-227ZS v1.3

[lepricon]

Hello all. Does anybody has any success with this v1.3 board?
I've tried to flash the device with the firmware mentioned for v1.2 of the board in (#161), but the board doesn't response after flashing. The worst part is that flashing ff.zip or bin/ZG227Z_v0133.bin didn't wake the board.

Any ideas?

The QR code on the board reads ZG-227ZS-_176oc9_29508

[soosp]

Hi, I just flashed three ones with ZigbeeTlc 1.3.4. They are working well.
I used an FTDI FT232R USB to UART converter (set to 3.3V). There was three wire connected:

DTR -> Bat+ (fifth hole started from the rectangular one)
GND -> Bat- (fourth hole)
TX -> SWS (middle hole)

The TSLR825x USB-COM Flash Writer was used
The source of sensors: https://www.aliexpress.com/item/1005008570513367.html