Description

Easy to use/port Modbus RTU slave library, written microcontrollers in mind.

Usage

1. Include the header and source file paths within your toolchain (Makefile or your IDE):

C_SOURCES =  \
    ... \
    modbus_lib/modbus_lib.c \
    modbus_lib/modbus_crc.c

C_INCLUDES =  \
    ... \
    -Imodbus_lib

2. Include the header file within your main.c:

#include "modbus_lib.h"

3. Implement the following functions in your application:

• Read handler:

uint16_t modbus_lib_read_handler(uint16_t la){ // la: logical_address
    switch(la){
        case 40001:
            return something; 
        case 40002:
            return something_else;
        case 40003: 
            if (some_error){
                return modbus_lib_send_error(MBUS_RESPONSE_SERVICE_DEVICE_FAILURE);
            } else {
                return some_other_value;
            }
        default:
            return modbus_lib_send_error(MBUS_RESPONSE_ILLEGAL_DATA_ADDRESS); 
    }
}

• Write handler:

uint16_t modbus_lib_write_handler(uint16_t la, uint16_t value)
{
    if ( la > 40000 && la <= 40013 ){
		my_buffer_reg_4xxxx[la-40001] = value;
    }
	if( la > 40013 && la < 40018){
		if(!writeEEprom(value))
		{
			return 	MBUS_RESPONSE_SERVICE_DEVICE_FAILURE;
		}
	}
    if (la == 40018 ){
	    output = (value >> 8) | (value << 8);
    }
    
    if (la > 40018){
	    return MBUS_RESPONSE_ILLEGAL_DATA_ADDRESS;
    }
    return MBUS_RESPONSE_OK; // data is successfully written
}

• Place the data receive function inside your incoming stream:

void USART2_dataHandler(void)
{
  uint8_t buff[1]; 
  HAL_UART_Receive (&huart2, buff, 1, 400);  
  modbus_lib_append_data(buff[0]); // append byte-by-byte
}

• Trigger the end of telegram after a timeout:

void USART2_idleHandler(void)
{
    modbus_lib_end_of_telegram();
}

• Implement write function:

int modbus_lib_transport_write(uint8_t* buffer, uint16_t length){
    HAL_UART_Transmit(&huart2, buffer, length, 1000);
    return 0; 
}

4. Make Modbus slave configuration and initialize in your main() function:

ModbusConfig_t modbus_cfg = {
    .address = 1
}; 

modbus_lib_init(&modbus_cfg);

5. Debug:

• Verify that uint8_t g_modbus_lib_received_telegram[] is filled with received telegram.
• Verify that uint8_t g_modbus_lib_received_length has correct value.
• Examine uint8_t outgoing_telegram[] contents for outgoing telegram (use uint16_t oindex for length) inside modbus_lib.c.

Example

STM32F407 Discovery board example is available here.