Fix errors when compiling with servo support#3
Open
silvio-didonna wants to merge 1 commit intobq:masterfrom
silvio-didonna:master
Open
Fix errors when compiling with servo support#3silvio-didonna wants to merge 1 commit intobq:masterfrom silvio-didonna:master
silvio-didonna wants to merge 1 commit intobq:masterfrom
silvio-didonna:master
Conversation
With autobedlevel enabled on prusa i3 hephestos (1st gen). However after send G29 gcode command the encoder stop working. Display and serial interface still working fine.
Author
|
There is an error in commit description: I wanted to write G28. |
|
From what I can see, it's not so much the G28 command that's causing the encoder to crash but rather the M280 command. From what little I've looked in to it so far it would appear that commenting out the "PROBE_SERVO_DEACTIVATION_DELAY" the encoder no longer crashes, but the probe arm is instead locked in one place and will not move at all. |
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
2 participants
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
With autobedlevel enabled on prusa i3 hephestos (1st gen). However after send G28 gcode command the encoder stop working. Display and serial interface still working fine.