id2895: Add initial support

[BareMetalIoT]

Tested on my washing machine

[medusalix]

Hi, thanks for the PR 😀

As far as I can tell from your code, the only difference between ID 2895 and 2088 is the reduction of the maximum temperature for the cottons program, right?

If possible, could you send me a copy of the memory dump for your machine? I just want to make sure that we get all the offsets right, especially when it comes to the fault memory parsing, which is quite hard to test.

[BareMetalIoT]

As far as I can tell from your code, the only difference between ID 2895 and 2088 is the reduction of the maximum temperature for the cottons program, right?
Yes, everything else looks similar in Home Assistant.
Although I'd like to see more sensor / actor information in HA to prevent Miele Service intervention in case of problems,

Will try to read out the firmware.
I´m also an electrical engineer and thought it would be easy to improve the timing of the SFH 7250 with 1kOhm impedance and a transistor but it was a total disaster.
The ESP32-C3 works without transistor and 22k resistor.

[medusalix]

Thanks for sending me the memory dump. All the offsets look fine 😃