Update ENOR Profiles

[Sanderli25]

New and updated ENOR profiles.

[Liaely]

Out of interest, why do you have 3 different Scottish buttons in the ENSV profile (ENSV.json)?

The point with vacs stations is that you will only need 1 button per area, so with your current setup lacking Scottish Low (SCL_CTR), it can be done with only 1 button and 1 station_id of EG-Moray-High (the corresponding sector), and if you wanted a low button for Scottish, the station_id of EG-Moray-Low.
In regards to the station_id, we'd prefer it if you would use the sector station IDs (as specified above), rather than the position station_ids.
Thanks!

[Sanderli25]

Many thanks! I will update it to the corresponding Moray station IDs.

[Sanderli25]

@Liaely May I ask, what is the level split between EG-Moray-High and EG-Moray-Low and is the lateral limits the same as SCO-E logon sector?

[Liaely]

@Liaely May I ask, what is the level split between EG-Moray-High and EG-Moray-Low and is the lateral limits the same as SCO-E logon sector?

Vertical limits are as specified in the LoA (at FL255).
Lateral limits are smaller than ScAC North, I've included a capture to show just Moray High, Moray Low is similar.
ScAC East takes ScAC North & some parts of ScAC South on the east side.

At the southern end, the North Sea Area II has Tyne above (EG-Tyne) (see image 2, and LoA page 8) just south of Moray Low, though Scottish CAS is from FL195+. Tyne is covered by ScAC South, then ScAC East. I don't think that this is necessary to be included in any Polaris profile though.

Feel free to ask any other questions about our setup, either here or on Discord!

[Adrian2k]

List of requested changes sent internally